AD 82-24-06 R1

AD Final Rules - DRS_82-24-06_R.html
Copy URL
Print/Save as PDF
Document Versions
 Feedback
Details
AD Number:
82-24-06 R1
Document Type:
AD Final Rules
Docket Number:
Unknown
Subject Heading:
Airworthiness Directives; Britten Norman Model BN-2, BN-2A, BN-2A-6, BN-2A-8, BN-2A-9, BN-2A-26, BN...Show more
Subject:
Carburetor Air Box Shutter
Status:
Current
Citation:
This information is not available.
Citation Publish Date:
Effective Date:
02/07/1983
Make:
B-N Group Ltd.
Model:
BN-2 | BN-2A | BN-2A-26 | BN-2A-27 | BN-2A-6 | BN-2A-8 | BN-2A-9 | BN2A MK. III | BN2A MK. III-2 | B...Show more
Product Type:
Aircraft
Product Subtype:
Small Airplane
Affected AD:
Superseded AD:
Affected By:
Superseded By:
Service/Office:
Office of Primary Responsibility:
CFR Part Reference:
Part 39
Comments:
AIRWORTHINESS DIRECTIVES FINAL RULES: 82-24-06 R1
CITATION:   This information is not available.

PAGE NUMBER:  

DOCKET NUMBER:   Unknown

AMENDMENT:   39-4559

AD NUMBER:   82-24-06 R1

SUBJECT HEADING:   Airworthiness Directives; Britten Norman Model BN-2, BN-2A, BN-2A-6, BN-2A-8, BN-2A-9, BN-2A-26, BN-2A-27, BN2A MKIII, BN2A MKIII-2, and BN2A MKIII-3 Series Airplanes

ACTION:  

SUMMARY:  

DATES:   Effective February 7, 1983.

ADDRESSES:  

FOR FURTHER INFORMATION CONTACT:  

SUPPLEMENTARY INFORMATION:  

REGULATORY TEXT:  
82-24-06 R1 BRITTEN-NORMAN: Amendment 39-4506 as amended by Amendment 39- 4559. Applies to Models BN-2, BN-2A, BN-2A-6, BN-2A-8, BN-2A-9, BN-2A-26, BN-2A-27, BN2A MKIII, BN2A MKIII-2, and BN2A MKIII-3 (all serial numbers) airplanes certificated in any category.

COMPLIANCE: Required as indicated unless already accomplished.

To prevent possible failure of the carburetor air box shutter, accomplish the following:

(a) Within the next 100 hours time-in-service after the effective date of this AD and at intervals not exceeding 100 hours time-in-service thereafter:

(1) Visually inspect the carburetor air box shutters for cracks or excessive bolt hole wear in accordance with procedures set forth in the "Inspection" section of Pilatus Britten-Norman Limited Service Bulletin Number BN-2/SB.144, Issue: 1, dated July 10, 1980 (hereinafter referred to as the service bulletin).

(A) Prior to further flight, replace any carburetor air box shutter found cracked with new shutter in accordance with "Rectification" section of the service bulletin.

(B) If excessive bolt hole wear is found prior to further flight, modify the shutter in accordance with the "Rectification" section of the service bulletin.

(b) On or before November 1, 1983, replace or modify the air box shutter in accordance with paragraph (a)(1)(A) or (a)(1)(B) of this AD.

(c) The inspection required by paragraph (a) (1) may be discontinued when the modifications or replacements prescribed in paragraphs (a)(1)(A) and (a)(1)(B) of this AD are accomplished.

(d) The airplane may be flown in accordance with FAR 21.197 to a location where this AD may be accomplished.

(e) An equivalent means of compliance with this AD may be used if approved by the Manager, Aircraft Certification Staff, AEU-100, Europe, Africa, and Middle East Office, FAA, c/o American Embassy, Brussels, Belgium.

Amendment 39-4506 became effective on December 2, 1982.
This Amendment 39-4559 becomes effective February 7, 1983.

FOOTER: